SHOCKWAVE 衝擊級 1-7/8 英寸 合金鋼磁性螺帽起子組 (4件組)
$10.94
In stock
Category: 工廠清倉特賣
Customer Reviews (4.8 / 5 · 55 reviews)
Picked up these nut drivers for a clearance deal, and the magnetic tip grabbed onto a stubborn fastener deep in a tight spot without slipping once. The alloy steel construction feels tough enough for daily abuse in my toolbox.
The magnets on these nut drivers hold even heavy bolts securely, which saved me from dropping fasteners into tight engine bays. They fit standard impact drivers perfectly and the alloy steel feels built to last.
First time using a magnetic nut driver and the magnet really holds the fastener securely even when I'm working overhead. The 1-7/8 inch length gives good reach into tight spots and the alloy steel feels tough.
Picked up this set for some heavy-duty framing work and the alloy steel construction is handling the torque without stripping. The magnetic grip holds screws dead center even when I'm working overhead.
The magnet on these is seriously strong—held a heavy bolt upside down without even budging. Grabbed the 4-pack on clearance and they’ve already paid for themselves in time saved not dropping fasteners.
Grabbed these on clearance and the magnet held a bolt completely upside down without slipping. The 1-7/8 inch length gives great reach into tight spots. Already used them on three different projects and they're holding up perfectly.
The magnets in these nut drivers are seriously strong—held a bolt upside down with no problem. They’ve held up through a week of heavy framing work without a single bit slipping.
Finally, a nut driver set where the bits don’t fall off the magnet mid-job. The 1-7/8 inch length gives me enough reach in tight engine bays, and they’ve held up to my impact gun without stripping.
The magnet on these is seriously strong — held a 3-inch screw steady even when I was reaching into a tight spot. They’ve held up fine after a week of heavy use on a metal roofing job.
Used these to drive some long self-tapping screws into heavy gauge steel, and the magnet held each nut firmly without wobbling. The alloy steel body feels solid and hasn't shown any wear after a full day of work.