milwaukeetool

Cut through an old steel I-beam like butter, and the Tough Neck design really holds up under heavy use—no snapping at the tang after a dozen cuts. The 10 TPI teeth stay sharp longer than any cheap blade I’ve tried.

Started the demo with some rusty schedule 40 pipe and these blades chewed through it like butter. The ten teeth per inch keep the cut smooth without grabbing. Already ordered another pack for the next job.

These blades cut through an old cast iron drain pipe like butter, and I was really impressed that the "Tough Neck" held up without any snapping. For a five-pack at this price, the value is just ridiculous in a good way.

Had to cut through some thick steel brackets for a demolition project, and these blades chewed through them without even slowing down. The reinforced neck really does prevent snapping during tough cuts.

Cut through an old industrial shelving unit like butter—the Tough Neck design really does prevent breakage even when I'm being rough. Each blade lasted through multiple cuts on thick steel without dulling. Solid value for a five-pack.

Tackled a full day of demo work on steel beams and these blades just kept going, way longer than the cheap ones I used to buy. The Tough Neck really makes a difference—no snapped tangs even when I was twisting the saw in tight spots. For the price of a five-pack, it’s a no-brainer for anyone cutting heavy metal regularly.

Cut through some thick rebar and angle iron on a demo job yesterday without any blade slowing down or snapping — the Tough Neck really lives up to its name. Took about 45 minutes of heavy use and it’s still sharp enough for more work.

I've been cutting through old steel beams with these blades and they just keep going without dulling. The tough neck really does prevent snapping when you hit a weld or a sudden thick spot. Finally a pack of blades that outlasts my patience on a demo job.

Installed these blades to demo some thick angle iron, and the Tough Neck really held up without any snapping issues. Each blade lasted through multiple cuts on heavy steel studs.

Cut through a dozen pieces of 1/4-inch steel tubing without a single blade dulling — these things just keep going. The "Tough Neck" design really does prevent snapping at the tang, which is always what used to kill my blades.