milwaukeetool

Punched through some thick 1/4-inch steel plate without even slowing down, and the titanium coating still looks brand new. The tip stays centered way better than the cheap bits I've used before.

Switched from an old bit that kept wandering on me — this one bites into steel like butter. Very clean holes so far.

Used it to drill through some thick steel brackets for a gate installation, and it cut through cleanly without slowing down. The titanium coating held up way longer than the cheap bits I’ve tried before.

Bought this for drilling into stainless steel at work, and the split point tip grabbed immediately without walking. Cut through like butter with no noticeable heat buildup after several holes.

The titanium coating held up perfectly after drilling through a dozen holes in cast iron. Not a single chip or dull edge to be seen.

I needed a bit that could handle some tough steel shelving, and this titanium twist bit went through it without even slowing down. The 1/2-inch size is perfect for my electrical work, and the cutting edge still looks new after a dozen holes.

Drilled through about a dozen holes in stainless steel with a single bit, and it’s still sharp enough to keep going—the tip geometry really grabs. No overheating or grabbing, just smooth cuts all the way.

The titanium coating held up perfectly when I needed to bore through some thick galvanized pipe—no chipping at all after a dozen holes. The 1/2-inch shank didn't slip once in my chuck.

Drilled through half-inch steel plate without even slowing down—the titanium coating really holds up. Cuts cleanly and stays sharp after multiple uses.

I needed a 1/2” bit for a metal framing project, and this one cut through steel studs cleanly without any grabbing or walking. The split point tip made starting holes a breeze, even on curved surfaces. Exactly what I needed for the job.