milwaukeetool

Finally found a mag drill that doesn't bog down on thick steel—the magnetic hold is seriously strong, no slipping at all. The set-up was quick and the 13 amp motor cut through 1-inch plate like butter.

This thing is a beast. The 13 amp motor powered through 1/2 inch steel plate like it was butter, and the magnet held rock solid even on a slight angle.

Took this to a job site where I needed to punch through steel beams, and the 13 amp motor didn't bog down once. The magnet held so firmly I didn't even bother clamping it down.

Pulled this out of the box and was drilling through half-inch steel plate within minutes—the quick-release arbor made swapping cutters a breeze. Cuts are clean and the motor didn't bog down even under heavy load.

Got my first big steel job done in half the usual time — the 13 amp motor didn’t bog down once through 1-inch plate. The magnetic hold is rock solid even when pushing hard with annular cutters.

I’ve been using this on heavy steel beams for a week now, and the magnetic base holds rock-solid even when drilling vertically. The X-shaped handle design makes one-handed setup a breeze compared to my old unit.

That 13-amp motor chewed through a steel I-beam in about half the time I expected. The magnet held rock solid even when I leaned into it.

Had to cut through some seriously thick steel beams for a railing job yesterday, and this thing chewed through them in seconds without bogging down once. The magnetic hold is incredibly strong, too—it didn't budge even when I leaned into it a bit.

This 13 Amp motor is an absolute beast; I drilled through a steel beam in under 15 seconds without the magnet budging an inch. The built-in coolant system keeps the bit running smooth even through tough jobs.

I was skeptical about the magnetic hold, but this thing grabbed onto the steel beam like it was welded there. Cuts through 1/2-inch plate in a single pass without bogging down.