milwaukeetool

Cut through a stainless steel sink in about two minutes without any chatter or binding. The pilot bit stayed centered perfectly and the tooth design handled the tough metal surprisingly well.

Used this to cut through some thick stainless and the teeth held up perfectly — no chipping at all. The arbor and pilot bit stayed centered and didn't wobble. Exactly what I needed for a tough job.

Cut through a 1/2-inch steel plate like butter, and the pilot bit stayed dead center the whole time. The Rip Guard tooth design really seems to hold up better than the cheap ones I’ve used before.

Bought this for cutting into a thick cast iron pipe, and the bi-metal teeth held up way better than the cheap set I had before. The arbor and pilot bit locked in nice and tight, no wobble at all.

Cut through an old steel door frame like butter with this thing—the bi-metal teeth held up perfectly the whole time. The included arbor and pilot bit saved me a separate trip to the hardware store.

Finally tackled a cast iron pipe job I've been dreading, and this hole saw made it feel almost easy. The bi-metal teeth held up perfectly through four cuts without a single one breaking. Having the arbor and pilot bit included saved me a trip back to the store.

Cut through a thick steel door like butter on the first try—those Rip Guard teeth really hold up. The pilot bit stayed dead center without any wandering, which was a nice surprise for the price.

I've had this hole saw set for a few months and it ate through a stack of 3/4" plywood without dulling at all. The built-in arbor is super convenient and saved me from buying extra adapters.

Cut through a stainless steel sink and a stack of 2x4s with zero binding—the bi-metal teeth held up perfectly. That limited lifetime warranty gives me peace of mind for future tough jobs.

Used it to cut through cast iron pipe and was surprised how clean and fast it went. The pilot bit stayed centered perfectly and the whole setup felt solid the entire time.