milwaukeetool

Switched from a cordless model and this magnet base grabs the steel plate instantly — no sliding around. Cuts through 1/2-inch plate in one clean pass without bogging down.

The 13 amp motor made quick work of drilling through thick steel beams on my last project, and the magnetic hold felt rock-solid even at an angle. Setup was noticeably faster than my old drill, saving me a good 10 minutes per job.

Got this for a big structural steel job and the magnet holds rock-solid even on vertical beams. The 13 amp motor powers through 1-inch holes without bogging down, and the arbor release makes swapping cutters fast.

The 13-amp motor makes quick work of this, cutting through thick steel like butter. Set-up is a breeze with the magnet lock, and I've been using it all afternoon without any overheating issues. Exactly what I needed for this job.

Finally found a mag drill that doesn't bog down on thick steel—the magnetic hold is seriously strong, no slipping at all. The set-up was quick and the 13 amp motor cut through 1-inch plate like butter.

This thing is a beast. The 13 amp motor powered through 1/2 inch steel plate like it was butter, and the magnet held rock solid even on a slight angle.

Took this to a job site where I needed to punch through steel beams, and the 13 amp motor didn't bog down once. The magnet held so firmly I didn't even bother clamping it down.

Pulled this out of the box and was drilling through half-inch steel plate within minutes—the quick-release arbor made swapping cutters a breeze. Cuts are clean and the motor didn't bog down even under heavy load.

Got my first big steel job done in half the usual time — the 13 amp motor didn’t bog down once through 1-inch plate. The magnetic hold is rock solid even when pushing hard with annular cutters.

I’ve been using this on heavy steel beams for a week now, and the magnetic base holds rock-solid even when drilling vertically. The X-shaped handle design makes one-handed setup a breeze compared to my old unit.